Dell 1GB Lom Daughter Card for Dell Emc PowerEdge R440

Part number KWJGX

Request a quote

DELL 1GB LOM DAUGHTER CARD FOR DELL EMC POWEREDGE R440 / R540 - LAN ON MOTHERBOARD ( 2 ) TWO RJ45 PORTS ( REQUIRES BRACKET AND X3 SCREWS KIT PN: 3U000 / 1P9KM )

Works with these servers

Configure a complete server with live pricing

Frequently asked questions

Why does the iDRAC display CPU speed in MT/s instead of MHz or GHz on my server?

This is a known presentation error in iDRAC9 where the CPU speed is incorrectly labeled as MT/s instead of MHz or GHz. It does not indicate a hardware or firmware issue, but rather a unit-labeling mistake in the user interface. [community thread]

What should I do if my PowerEdge R7515 shows a POST error?

To address a POST error on your PowerEdge R7515, ensure that the firmware is updated to the latest version and run the built-in hardware diagnostics by booting into the LifeCycle Controller. Take note of any errors that arise during the diagnostics for further investigation. [community thread]

Where can I find the supported hardware components for Dell R430, R440, R730, and R740 servers?

Documentation for supported hardware components for the Dell R430, R440, R730, and R740 servers can be found in their respective technical guides. For detailed specifications, refer to the manuals available on Dell's support website, or contact the sales department for information on any unsupported hardware. [community thread]

What cables and components are needed to retrofit an R440 server for NVMe support?

For retrofitting the R440 to support NVMe drives, it's advisable to refer to the user manual for accurate cabling instructions. A PCIe extender card may be necessary if utilizing the SAS drive slots, and ensure that the SAS cables are of adequate length to connect to the HBA card. [community thread]

Why does my R440 reboot when the UPS switches to battery power?

The reboot may be due to the UPS outputting a simulated sine wave, which can cause the R440's power supply to lose sync and restart. Ensure the UPS provides a pure sine wave output and has a transfer time of less than 4 ms. Additionally, check for firmware updates for both the UPS and the R440. [community thread]