Dell 1X16 RISER3 Board for Dell Emc PowerEdge R7525 - Riser

Part number VTC3V · also known as RISER3

Request a quote

DELL 1X16 RISER3 BOARD FOR DELL EMC POWEREDGE R7525 - RISER 3 CARD ( 1 ) ONE PCI-E 4.0 X16 INTERFACE ( BRACKET PN: 6053B1677801 )

Works with these servers

Configure a complete server with live pricing

Frequently asked questions

What GPUs are compatible with the PowerEdge R7525 and what is the maximum power draw?

For compatible GPUs and recommended slots, consult the technical guide, specifically page 27. The maximum power draw for GPUs is detailed in the table on page 7. [community thread]

What should I do if my Dell R7525 server gets stuck at the IDRAC initializing screen with solid DS0 and DS3 LED lights?

First, ensure that the CPUs and memory modules are properly seated and compatible. Clear the NVRAM by using the onboard jumper or removing the battery to reset the BIOS settings. If the issue persists, it may indicate a fault with the motherboard. [community thread]

How can I determine if my Dell R7525 server chassis is OEM or not?

To identify if your R7525 chassis is OEM, check the service tag on the Dell support page. If it is OEM, the support page will explicitly indicate this. [community thread]

What cables are needed for an H755N Front NVMe RAID card in a PowerEdge R650xs server?

The H755N requires NVMe-specific cables, which are different from those used for SAS PERC cards. Ensure that your server's configuration supports the necessary backplane for the H755N, as it typically accommodates specific drive setups. [community thread]

How can I set PXE as the primary boot device on a PowerEdge R7525 running in UEFI mode?

To set PXE as the first boot option, access the System BIOS Settings, navigate to Boot Settings, and then UEFI Boot Settings. You may need to disable other boot options to ensure that PXE remains the primary boot device, as changes to the UEFI boot sequence may not persist otherwise. [community thread]