Refurbished Dell PowerEdge R750

Request a quote — built to order from tested, warrantied stock.

The Dell PowerEdge R750 is a refurbished 2U Rack server (15G) for the 3rd Generation Intel Xeon Scalable, DDR4 · up to 8192 GB · 32 DIMM slots · up to 3200 MT/s · 8 channels per CPU · ECC. Drive layouts: 12x 3.5-inch SAS/SATA; 12x 3.5-inch w/ rear 2x 2.5-inch SAS/SATA or NVMe; 12x 3.5-inch SAS/SATA + 4x 2.5-inch SAS/SATA or NVMe; 8x 2.5-inch NVMe; 8x 2.5-inch NVMe RAID; 8x 2.5-inch Universal. Every unit is tested, warrantied and shipped from Canada; configure it online with parts that are checked for compatibility.

Best for: storage, virtualization.

Configure this server online

Specifications

Form factor2U Rack
Generation15G
CPU2 socket(s) · 3rd Generation Intel Xeon Scalable · LGA4189
MemoryDDR4 · up to 8192 GB · 32 DIMM slots · up to 3200 MT/s · 8 channels per CPU · ECC
Drive bays12x 3.5-inch SAS/SATA; 12x 3.5-inch w/ rear 2x 2.5-inch SAS/SATA or NVMe; 12x 3.5-inch SAS/SATA + 4x 2.5-inch SAS/SATA or NVMe; 8x 2.5-inch NVMe; 8x 2.5-inch NVMe RAID; 8x 2.5-inch Universal
Storage controllersPERC H345, PERC H355, HBA355i — 12Gb SAS HBA passthrough, internal, PERC H745, PERC H755, PERC H755N · boot: BOSS S2 module, BOSS S1 Full height, BOSS S1 Low profile, BOSS 1.5 · M.2 boot
PCIeGen 4.0 · 8 slots
Networking2x 1GbE LOM · OCP 3.0 slot
GPUup to 8 GPUs · 2 double-width
Power700W Titanium, 800W Platinum, 1100W Titanium, 1400W Platinum, 1800W Titanium, 2400W Platinum, 2800W Titanium, 1100W Titanium, 1100W Platinum · redundant · hot-swap
ManagementiDRAC9 · iDRAC9 Express
CoolingASHRAE A4 · hot-swap fans

Chassis configurations

Typical refurbished configuration

Real parts from our catalog for this chassis, priced from live market listings and vendor offers:

Processors

Memory

Drives

Chassis pricing is quoted by our team; component prices come from live market listings and vendor offers and are refreshed nightly. Lines without market evidence are quoted by our team.

Compare with similar Dell servers

Frequently asked questions

What parts are needed to install a GPU on a PowerEdge R750XS server?

The PowerEdge R750XS does not have a specific GPU enablement kit, and there is no documented support for GPU configurations. For detailed information, refer to the technical guide provided by the manufacturer. [community thread]

Why isn't a second CPU recognized after reinstalling it in a PowerEdge R750?

This is almost always a seating issue — power down, remove the processor and heatsink, then reinstall and torque all four corner screws evenly. If it still isn't detected in iDRAC, update BIOS/iDRAC firmware and run the Lifecycle Controller's repurpose option so the CPLD re-registers the second socket. [community thread]

Which power cable do I need for a 16-pin (12VHPWR) GPU in a PowerEdge R750?

The standard R750 GPU power kit ships with 12-pin to 8-pin and 12-pin to dual 6+2 cables, which don't fit 16-pin cards. Dell offers several GPU installation kits for the R750 keyed to the specific GPU model, so the right kit part number depends on which card you're installing — check the kit matched to your GPU before ordering. [community thread]

What should I check when an NVIDIA Tesla M10 throws a warning in R750 integrated diagnostics?

Start by reviewing the Lifecycle Controller logs (F10 at boot) for details on the warning, confirm System BIOS and iDRAC are current, and reseat the card — slot position and auxiliary power connections matter for the M10. If the warning persists after a reseat and firmware update, the card itself may need swapping to isolate hardware vs. configuration. [community thread]

Are Micron 7500 U.3 NVMe disks compatible with Dell R750 servers?

The Micron 7500 U.3 NVMe disks are not compatible with Dell R750 servers, which only support U.2 drives. Therefore, there is no firmware available for U.3 disks on this server model, and users should consult Micron for further assistance. [community thread]

How can I remove UEFI boot order entries on a PowerEdge R750 server?

To delete UEFI boot entries, access the UEFI Boot Manager by pressing <F11> during startup. From there, you can select the option to delete existing boot options. [community thread]

How can I convert an R750 server into a vSAN ESA ReadyNode?

To convert an R750 into a vSAN ESA ReadyNode, it is recommended to use an HBA355. However, be aware that changes to the storage configuration after purchase are not supported, and there are no kits available for modifications. [community thread]

What should I do if my Ubuntu OS installation via NFS on iDRAC 10 fails frequently?

To resolve installation failures, first ensure that both iDRAC and BIOS are updated to the latest versions. For better results, try installing on a single host before scaling up, and consider using a dedicated HTTP server for ISO delivery instead of co-hosting with NFS. As a temporary solution, using PXE/iPXE or local media for installations may help avoid issues during batch provisioning. [community thread]