Part number FYRGC · also known as 005MP · HN8FW · RISER2
Request a quote
DELL 1X16 RISER2 ASSEMBLY KIT FOR DELL EMC POWEREDGE R450 - RISER 2C CARD WITH BRACKET ASSY ( R2C LP - HALF HEIGHT / LOW PROFILE ) ( 1 ) ONE PCI-E 4.0 X16 INTERFACE - ( BOARD PN: 005MP / CAGE PN: HN8FW )
Configure a complete server with live pricing
To resolve HWC8010 and UEFI0459 errors, first reseat the PERC 755 RAID card and any associated risers, ensuring they are in the correct slots. Next, access the BIOS/iDRAC settings to accept the current hardware configuration as valid. If the issue persists, check for firmware updates or temporarily remove the PERC card to see if the error clears. [community thread]
Yes, the Dell PowerEdge R650 can support this configuration using the S150 PERC software controller, which does not require a hardware RAID card. For software RAID, ensure that you are using compatible Dell NVMe drives and check the specifications for any additional requirements. [community thread]
When replacing the backplane and controller in a Dell R650 server, it's important to note that the necessary cables may not be included with the new components. It is recommended to contact local support or raise a ticket to ensure you receive the correct cables for your setup. [community thread]
The H755N requires NVMe-specific cables, which are different from those used for SAS PERC cards. Ensure that your server's configuration supports the necessary backplane for the H755N, as it typically accommodates specific drive setups. [community thread]
The error is likely due to an unbalanced memory channel configuration, which does not comply with Dell's memory population guidelines. To resolve this, ensure that each channel has an equal number of DIMMs and that the total count of DIMMs matches the supported configurations for your CPU. [community thread]