Dell HBA330 12G Mini Mono SAS Controller

Part number P2R3R · also known as R75VT

Price: $21.00 USD

Dell HBA330 Minicard 12GB/S SAS Eight Port Non RAID Card - Host Bus Adapter 330 Supports 6GB/S SATA 8-Port PCI-E 3.0 X8 Speeds ( NON-RAID Controller )

Specifications

ports8
form factorpcie
component typehba
controller familyHBA330 MiniCard

Works with these servers

Configure a complete server with live pricing

Frequently asked questions

What should I do if my PowerEdge R740xd is stuck at boot after switching from RAID to HBA mode?

To resolve the boot issue, revert the PERC controller back to RAID mode via iDRAC and perform a cold power cycle for 30 to 60 seconds. After rebooting, access the System Setup to delete any old UEFI boot entries, clear all configurations in the PERC settings, and ensure that your BIOS, iDRAC, and PERC firmware are updated before switching back to HBA mode. [community thread]

What does the PCI1318 error mean on a T440 server and how can it be resolved?

The PCI1318 error on a T440 server may indicate an issue with the Broadcom network interface cards when using kernel versions greater than 6.5. Disabling these network cards in the system BIOS can allow the server to boot without errors. Alternatively, replacing the network card with a compatible one can also resolve the issue. [community thread]

Why can't I see my PCIe storage card drives as boot options in the R740xd?

Ensure that the PCIe storage card is compatible with the R740xd, as only specific models are validated for this server. Additionally, check the BIOS settings to confirm that the boot mode is correctly configured. [community thread]

What should I do if the Riser 1A length interferes with the PERC H330 mini in my R740XD server?

Consider using a different riser slot, such as Riser 2 or 3, for your GPU installation. Additionally, ensure you have the necessary GPU enablement kit components to facilitate proper installation. [community thread]

How can I resolve the persistent battery missing alert on my PowerEdge R630 with a PERC H730p?

This alert is a normal indication of a missing Cache Protection Module (CPM) and cannot be permanently disabled. To address the issue, ensure the controller is properly seated and check the battery connections. Additionally, updating the PERC and iDRAC firmware may help with detection issues. [community thread]