Dell Heatsink Dell PowerEdge R240/R340/R350 High Performance >95W

Part number RY3PC

Request a quote

Heatsink Dell PowerEdge R240/R340/R350 High Performance >95W

Works with these servers

Configure a complete server with live pricing

Frequently asked questions

What should I do if my PowerEdge R250 won't power on after adding components?

If your server shows no signs of power, indicated by blinking LEDs, it may be experiencing a 5V SW fault. Begin troubleshooting by disconnecting all USB devices, checking for shorts in the iDRAC Direct cable and video connections, and removing the front control panel cable. If the issue persists after these steps, consider testing with minimal components or replacing the motherboard. [community thread]

Why is my Dell PowerEdge R350 server showing 'No memory found' after adding new RAM?

Ensure that all installed DIMMs are DDR4 and compatible with the server. Check that the memory modules are correctly seated and that a processor is installed, as memory sockets can only be populated in this case. For detailed installation guidelines, refer to the official documentation. [community thread]

Is the Broadcom NetXtreme II 10 GB-2 port PCI Express x8 compatible with the PowerEdge R250 server?

The Broadcom NetXtreme II 10 GB-2 port PCI Express x8 is not compatible with the PowerEdge R250 server, as it is designed for use with up to 14G models, while the R250 is a 15G model. [community thread]

Is Samsung server memory and Seagate Ironwolf Pro hard drives compatible with the Dell PowerEdge R250?

The Samsung server memory and Seagate Ironwolf Pro hard drives are not certified or tested by Dell for compatibility with the PowerEdge R250. Therefore, their performance cannot be guaranteed unless confirmed by a user who has tested them. [community thread]

What screw sizes are needed for the PERC card tray on a Dell R350 server?

The required screws for the PERC card tray are M3 x 3.6mm. You will need a total of four screws for proper installation. [community thread]