Part number W9W0D
Request a quote
PowerEdge R650 R6525 R750 PERC H755N PCIe NVMe Signal Cable
| ism to | BP_DST_PA1 |
|---|---|
| ism from | CTRL_SRC_PA1 |
| topology | nvme_split |
| interface | NVMe |
| ism to list | ['BP_DST_PA1', 'BP_DST_PB1'] |
| ism endpoint source | operator_research_2026-05-17 |
Configure a complete server with live pricing
The PowerEdge R750XS does not have a specific GPU enablement kit, and there is no documented support for GPU configurations. For detailed information, refer to the technical guide provided by the manufacturer. [community thread]
When replacing the backplane and controller in a Dell R650 server, it's important to note that the necessary cables may not be included with the new components. It is recommended to contact local support or raise a ticket to ensure you receive the correct cables for your setup. [community thread]
To convert an R750 into a vSAN ESA ReadyNode, it is recommended to use an HBA355. However, be aware that changes to the storage configuration after purchase are not supported, and there are no kits available for modifications. [community thread]
The required part numbers are WTHHV for the 12x3.5-inch SAS/SATA cable assembly and R4C4X for the micro cable assembly. It's advisable to verify these numbers against the documentation to ensure accuracy. [community thread]
If your server indicates a backplane connection error, ensure that all necessary cables from the motherboard to the backplane are securely connected. If the issue persists, refer to the manufacturer's documentation for troubleshooting steps or check for similar configurations to verify cable connections. [community thread]