Dell 1100W Titanium PSU

Part number J9N6W

Request a quote

Dell Poweredge 15G 16G R650 R6525 R660 R750 R7525 1100W 80Plus Titanium 100-240V Power Supply

Specifications

inputAC
component typehot_plug

Works with these servers

Configure a complete server with live pricing

Frequently asked questions

What GPUs are compatible with the PowerEdge R7525 and what is the maximum power draw?

For compatible GPUs and recommended slots, consult the technical guide, specifically page 27. The maximum power draw for GPUs is detailed in the table on page 7. [community thread]

What does the error 'CPU 1 VCCIO PG Voltage Is Outside of Range' mean on a PowerEdge R760?

This error is typically associated with issues in the motherboard's voltage regulation or CPU seating. To troubleshoot, perform a power drain, check for firmware updates, and inspect the CPU for any bent pins or debris. If the problem continues, the motherboard may need to be examined. [community thread]

Can the R760 server support two Nvidia L40 video cards?

Yes, the R760 server with dual CPUs can accommodate two Nvidia L40 GPUs, as they are double-width and within the power specifications. Ensure you have a power supply of at least 1600W and the appropriate GPU riser kit, power cables, and cooling components for optimal performance. [community thread]

What do the LED codes on the R660 motherboard indicate when the server fails to boot?

The LED codes on the R660 motherboard can signal various issues, such as a 5V switch fault or problems with connected USB devices, iDRAC cables, or the rear I/O card. To troubleshoot, perform a flea power drain, clear the NVRAM, and test with only the minimum components necessary for POST. If the server still does not boot, further inspection of the components may be required. [community thread]

What power cable is needed to install a Nvidia A100-SXM4-40GB in a R760 server?

To connect the Nvidia A100-SXM4-40GB GPU in a R760 server, you will need the appropriate power cable. The correct part numbers to look for are 9PVH2 for Riser 4 and CPH58 for Riser 1, but it's advisable to verify compatibility before purchasing. [community thread]