Dell M.2 Hot Plug BOSS-N1 Mono Boot Controller Card Adapter

Part number WW56V

Price: $560.00 USD

DELL M.2 HOT PLUG BOSS-N1 MONO BOOT CONTROLLER CARD ADAPTER FOR DELL EMC POWEREDGE R660 / R760 / R760XA / R760XS / R7625 - BOOT OPTIMIZED STORAGE SUBSYSTEM BOSS - SUPPORTS ( 2 ) TWO M.2 2280 INTERFACES - REQUIRES SSD CARRIER ADAPTER / NOT INCLUDED ( TRAY

Specifications

Works with these servers

• Dell PowerEdge R7625
• Dell PowerEdge XE9680
• Dell PowerEdge R860
• Dell PowerEdge R6615
• Dell PowerEdge R7615
• Dell PowerEdge R960
• Dell PowerEdge R6625
• Dell PowerEdge R260
• Dell PowerEdge MX760c
• Dell PowerEdge R660
• Dell PowerEdge R760
• Dell PowerEdge R760xd2
• Dell PowerEdge R660xs
• Dell PowerEdge R760xa
• Dell PowerEdge R760xs

Configure a complete server with live pricing

Frequently asked questions

What does the error 'CPU 1 VCCIO PG Voltage Is Outside of Range' mean on a PowerEdge R760?

This error is typically associated with issues in the motherboard's voltage regulation or CPU seating. To troubleshoot, perform a power drain, check for firmware updates, and inspect the CPU for any bent pins or debris. If the problem continues, the motherboard may need to be examined. [community thread]

Why does the iDRAC display CPU speed in MT/s instead of MHz or GHz on my server?

This is a known presentation error in iDRAC9 where the CPU speed is incorrectly labeled as MT/s instead of MHz or GHz. It does not indicate a hardware or firmware issue, but rather a unit-labeling mistake in the user interface. [community thread]

Can the R760 server support two Nvidia L40 video cards?

Yes, the R760 server with dual CPUs can accommodate two Nvidia L40 GPUs, as they are double-width and within the power specifications. Ensure you have a power supply of at least 1600W and the appropriate GPU riser kit, power cables, and cooling components for optimal performance. [community thread]

What components are necessary for installing an NVIDIA L4 GPU in a PowerEdge R760xd2 server?

To install an NVIDIA L4 GPU in a PowerEdge R760xd2, you will need Riser Config 3A, a GPU enablement kit (part number 470-BBWW), and the NVIDIA L4 GPU itself (part number 490-BJRQ). Ensure that your server's BIOS and iDRAC are updated, and a power supply of 1100W or more is recommended for stable operation. [community thread]

What do the LED codes on the R660 motherboard indicate when the server fails to boot?

The LED codes on the R660 motherboard can signal various issues, such as a 5V switch fault or problems with connected USB devices, iDRAC cables, or the rear I/O card. To troubleshoot, perform a flea power drain, clear the NVRAM, and test with only the minimum components necessary for POST. If the server still does not boot, further inspection of the components may be required. [community thread]