DELL LI-ION PERC BATTERY 3.7V 500MAH FOR DELL EMC POWEREDGE

Part number 7XF2T · also known as JM7F5

Price: $196.00 USD

DELL LI-ION PERC BATTERY 3.7V 500MAH FOR DELL EMC POWEREDGE R550 / R660 / R6525 / R6625 / R750 / R7525 / R7625 - COMPATIBLE WITH RAID CONTROLLER H745 / H755N / H755 FRONT SAS ( HOLDER PN: JM7F5 )

Specifications

Works with these servers

• Dell PowerEdge R7625
• Dell PowerEdge R750xa
• Dell PowerEdge R6615
• Dell PowerEdge R7615
• Dell PowerEdge R6625
• Dell PowerEdge R750xs
• Dell PowerEdge R550
• Dell PowerEdge R660
• Dell PowerEdge R7525
• Dell PowerEdge R760
• Dell PowerEdge R750
• Dell PowerEdge R650
• Dell PowerEdge R660xs
• Dell PowerEdge R6525
• Dell PowerEdge R760xa
• Dell PowerEdge R760xs
• Dell PowerEdge R650xs

Configure a complete server with live pricing

Frequently asked questions

What GPUs are compatible with the PowerEdge R7525 and what is the maximum power draw?

For compatible GPUs and recommended slots, consult the technical guide, specifically page 27. The maximum power draw for GPUs is detailed in the table on page 7. [community thread]

What parts are needed to install a GPU on a PowerEdge R750XS server?

The PowerEdge R750XS does not have a specific GPU enablement kit, and there is no documented support for GPU configurations. For detailed information, refer to the technical guide provided by the manufacturer. [community thread]

What should I do if my Dell R7525 server gets stuck at the IDRAC initializing screen with solid DS0 and DS3 LED lights?

First, ensure that the CPUs and memory modules are properly seated and compatible. Clear the NVRAM by using the onboard jumper or removing the battery to reset the BIOS settings. If the issue persists, it may indicate a fault with the motherboard. [community thread]

What do the LED codes on the R660 motherboard indicate when the server fails to boot?

The LED codes on the R660 motherboard can signal various issues, such as a 5V switch fault or problems with connected USB devices, iDRAC cables, or the rear I/O card. To troubleshoot, perform a flea power drain, clear the NVRAM, and test with only the minimum components necessary for POST. If the server still does not boot, further inspection of the components may be required. [community thread]

Why isn't a second CPU recognized after reinstalling it in a PowerEdge R750?

This is almost always a seating issue — power down, remove the processor and heatsink, then reinstall and torque all four corner screws evenly. If it still isn't detected in iDRAC, update BIOS/iDRAC firmware and run the Lifecycle Controller's repurpose option so the CPLD re-registers the second socket. [community thread]